| Article number: | 1C0677GRN |
| Availability: | In stock |
DESCRIPTION
The Threadless Carrier is the easiest way to carry the 20-function EDC Tool in your stem. Just remove the star nut, drop it into your steerer tube and secure from below. Pop your EDC Tool into the carrier and hit the trail. Never forget your tools again.
FEATURES
This product is designed to hold the EDC V2 Tool; however, it is only compatible with the small EDC storage capsule - it is not compatible with the large EDC storage capsule
Fork Compatibility
Most forks are compatible, except for a small number of forks with very short steerer tubes.
For the following cases your fork steerer tube length must meet the minimum length requirement.
Fox Forks (excluding Fox Factory/Perf. Elite 38 forks) = 190mm min
Fox Factory/Perf. Elite 38 Forks = 245mm
RockShox Forks = 220mm min
All other compatible forks = 190mm min
*It's important to check your fork compatibility before purchasing
WHAT'S IN THE BOX
- EDC Threadless Carrier
- Star nut remover bolt and washer
- Lower cap
- 1x 40mm bolt
- 1x 60mm bolt
- 1x 80mm bolt
- 1x 100mm bolt
STEERER TUBE LENGTH
Most forks are compatible, except for a small number of forks with very short steerer tubes. For the following cases your fork steerer tube length must meet the minimum length requirement.
- Fox except Fox 38 with oval steerer = 190mm min
- RockShox Forks = 210mm min
- All other compatible forks = 190mm min
Measure from the underside of your fork crown to the top of your spacer stack, or top of your stem if you are not running any spacers above your stem.
